
I built this watch cleaning maching from 1/2 inch and 3/8 inch aluminum. It has a 24v power supply that powers the programmable speed controller and 24v motor. The motor carraige slides on a linear bearing and rod setup, keeping the unit consistantly straight and smooth when adjusting height.
I started this project by measuring and cutting the half inch aluminum plates for the base. After cutting to size, i drilled and tapped the holes for assembly.


Before proceeding, i assembled the electical components for testing.
After cutting the parts for the base, i did a quick test fit to ensure the components will fit nicely in the case. Now the holes for the base assembly can be drilled and tapped.




I then cut and mounted the motor mount plate, and drilled the motor shaft hole for test fit.
After test fitting the motor, i drilled a 37mm diameter resseced hole that will allow the motor to be pressed into place.


I then made a mount for the jar from a wide galvanized pipe, welded the mounting clips and blackened the parts for a nice gunmetal black finish. I then corked the interior of the mounts and top of baseplate to help with any spills.




You must be logged in to post a comment.